Application Guide

DMXking.com • JPK Systems Limited • New Zealand
0104-701-1.0
1
INTRODUCTION
All eDMX PRO, LeDMX PRO and ultraDMX2 PRO products with SD card holders are capable of recording any incoming Art-Net or
sACN stream sent from your lighting control system. DMXking recorders are built right into the output node, unlike other
standalone recorder products, which not only removes another layer of equipment/cost but also provides distributed highly
scalable near unlimited universe playback count. What you see at the output node is exactly what gets recorded.
Minimum firmware required v3.0+ Update to the latest firmware using eDMX Configuration Utility v1.14+ (Windows).
Features:
• Records whatever universes are configured on the device (i.e. eDMX4 PRO can record 4 universes)
• Up to 255 shows
• Scripted show playback
• Distributed recording and playback
• High capacity SD cards supported 32GB and beyond
• All protocols and merging supported by the device is also supported for recording
• Record from Art-Net and/or sACN sources
• Record DMX-IN ports for playback as DMX-OUT
• Record USB DMX sources (ultraDMX2 PRO and eDMX2 PRO only)
• Show playback can be triggered on:
o Power up
o ArtTrigger commands (broadcast and unicast)
o External contact closure (check hardware for accessory port support)
SD CARD
COMPATIBLE SD CARDS
For performance reasons we only recommend Samsung EVO Plus and Samsung PRO Plus SD cards which have been extensively
tested in DMXking hardware under maximum throughput conditions.
• Samsung EVO+ 32GB Model Code: MB-MC32DA
• Samsung EVO+ 64GB Model Code: MB-MC64DA
• Samsung PRO+ 32GB Model Code: MB-SD32D
• Samsung PRO+ 64GB Model Code: MB-SD64D
We anticipate adding more verified SD cards in the near future.
Most SD cards come pre-formatted with FAT32 or exFAT file systems. Both are FAT32 and exFAT are supported by the DMXking
recorder system and we recommend exFAT because file sizes >4GB are supported.
INSTALLATION / REMOVAL
Access to the internal SD card holder may require partial disassembly of the DMXking unit. This should be performed by a
competent technician or DMXking distributor. Antistatic precautions should be taken and power down the unit first.
Take care to operate the SD card holder correctly. Observe Open and Lock arrows and slide the top cover in the applicable
direction before hinging upwards. There is a reasonable force required to slide the top cover Open or Locked however almost no
force is required to hinge it upwards when Open.