User Manual

DMXking.com • JPK Systems Limited • New Zealand
0107-700-1.0
3
4. DEFAULT CONFIGURATION
All eDMX2 PRO units ship with default IP address settings. Please reconfigure for your requirements before use.
Parameter
Default Setting
IP Address
192.168.0.112
Subnet Mask
255.255.255.0
Default Gateway
192.168.0.254
DMX512 and Art-Net configuration parameters are also configured with default values.
Parameter
Default Setting
Network Mode
Custom IP address
*Operation Mode
DMX Out
*DMX Universe
1, 2 [Net 00, Subnet 0, Universe 0, 1]
Note sACN Universe 1 = Art-Net 00:0:0
*Merge Mode/Timeout all sources
HTP, Timeout un checked
*DMX512 Update Rate
40 [DMX512 frames per second]
*RDM Packet Spacing
1/20s
*RDM Discovery Period (TX mode)
/ sACN Priority (RX mode)
0s [RDM Disabled]
*Broadcast Threshold
0 [Force Art-Net broadcast]. Don’t change this unless you want Art-Net
II/III unicast on DMX In ports.
*Recall DMX Snapshot at startup
Recall unchecked
*These parameters are per port.
5. CONFIGURATION UTILITY
The eDMX Configuration utility provides a simple interface to all device parameters. Only version 1.11 and above is compatible
with eDMX2 PRO devices. Typically these are set once during initial configuration and left untouched. If you are not confident in
setting up network IP Address, Subnet Mask and Default Gateway parameters please get in touch with DMXking.com support
and we’ll walk you through the process. DHCP is not currently supported.
Special note: Once you’ve finished configuring your eDMX product close the application before starting your lighting control
application if it’s run from the same computer.