User Manual

DMXking.com • JPK Systems Limited • New Zealand
0107-700-1.0
2
STATUS LED TABLE
LED
Indication
Data (upper)
Protocol activity. Red = RX, Green = TX, Orange = Boot loader mode
Network (lower)
Network activity. Green = Link, Flash = Traffic
A (upper)
DMX512 Port A. Green = TX, Red = RX
B (lower)
DMX512 Port B. Green = TX, Red = RX
3. INSTALLING THE FTDI DRIVER
To use the USB DMX interface install the FTDI driver. Note this isn’t required for Art-Net or sACN operations. eDMX2 PRO
maximizes compatibility with existing software an FTDI ( www.ftdichip.com ) FT245RL device provides USB 2.0 Full Speed
interfacing. Drivers are available directly from FTDI and in most cases the VCP (Virtual COM Port) driver should be used although
both D2XX and VCP are installed by default on Windows OS. The latest drivers are available from
www.ftdichip.com/Drivers/VCP.htm
Please refer to the installation guides at www.ftdichip.com/Documents/InstallGuides.htm and note the process involved installs
2 devices, a USB serial device followed by USB virtual COM port. All required files are included in the driver installation file.
On occasion you may wish to change the COM port number an eDMX2 PRO unit has been assigned by Windows. This can be
done through the Device Manager applet by right clicking on the USB Serial Port of interest (unplug/re-plug the unit and observe
if unsure which COM port) then select properties, Port Settings tab, Advanced button and finally choose the desired COM Port
Number.