Product manual

OSC input/output plugin
Introduction
QLC+ supports the OSC protocol through an input plugin that receives packets from the network.
Requirements
The OSC protocol is available thanks to the liblo library, which is linked dynamically on Linux
systems and statically on Windows and OSX.
In other words, Windows and OSX don't need any extra software, while Linux systems need the
liblo library installed.
Configuration
The OSC plugin supports up to 4 inputs, one for each QLC+ universe. Each input has to listen to
a unique port and this can be configured from the plugin configuration panel.
For each OSC network the following parameters can be set:
Port: The port QLC+ will listen to receive OSC data from your external controller (Just enter
the same port your external OSC controller is using)
Output address: In case you need to output DMX data through the OSC plugin (either for
feedbacks), enter here the address to send to. This must be specified in the form:
IPAddress:port
Controllers
QLC+ has been tested with the following OSC controllers:
TouchOSC. A pre-defined input profile is ready to use for the Mix16 layout.
Page 85