Product manual

ArtNet input/output plugin
Introduction
QLC+ supports the ArtNet protocol through an input/output plugin that receives and transmits
packets on the network.
No extra requirement is needed, since QLC+ has a native implementation of the ArtNet protocol
that works on Linux, Windows and OSX systems.
Configuration
The ArtNet plugin can be configured to send and receive packets from multiple network cards,
virtual addresses and multiple universes per network card.
The desired configuration can be achieved quite easily by opening the plugin configuration
panel.
The dialog will show all the possible choices depending on the network interfaces that QLC+
detects when opened.
The dialog will display two lists:
The available networks and universes. Just click on the corresponding checkbox to enable
the one you're going to use and it will be listed in QLC+ input/output manager.
Networks and universes are displayed in the following form:
Network 1 - Universe 0
Network 1 - Universe 1
Network 1 - Universe 2
Network 1 - Universe 3
Network 2 - Universe 0
...
Network 2 - Universe 3
...
A simple node inspector that will display the available ArtNet nodes discovered on the
network
Compatibility
QLC+ has been tested with the following ArtNet softwares/devices:
DMXking eDMX2 TX - Output device
Enttec Open DMX Ethernet (ODE) - Output device
OLA - Open Lighting Architecture - Input/Output software node
ArtNet Controller LITE - Input controller for Android
Controlador ArtNet DMX (Lite) - Input controller for Android
Page 79