Product manual

Operate mode
When switching QLC+ to Operate Mode, the Cue List will become active, allowing the selection
of the desired steps included in the associated Chaser.
Four buttons are displayed at the bottom of the Cue List widget:
Start/stop the selected action in the Cue List
The previous action in the Cue List will be activated. When reaching the top, the
previous action will be the last of the Cue List
The next action in the Cue List will be activated. When reaching the bottom, the
next action will be the first of the Cue List
When clicked, this button will open/close a side panel showing two sliders.
Each slider is connected to an action and to understand their meaning we'll call
them "current action" and "next action" sliders. The label on the bottom will show
the corresponding color and number of the running action.
The checkbox on the top will link the sliders together for a linear transition
When the Cue list is running the sliders will control the intensity of the associated
actions, overriding their Fade In speed, to allow manual control of the transition
between two actions.
When the current action slider will reach zero value, the next action slider will turn
to blue, to indicate the action has been stopped and the Cue list moved to the next
action. At this point the next action slider becomes the current action and what was
current action becomes next action.
In this way it is possible to manually crossfade two sequential actions.
Hint
When a step is added to a Chaser using the Chaser Editor, the default duration is set to 0.
To avoid your actions in the Cue List to loop endlessly without any result, please set the duration
of your steps, either by double clicking on the duration field or by using the Speed Dial widget
Please note that if you need light scenes that you're going to change manually with the Cue List
widget, you might want to set the duration to "infinite" (∞) using the Speed Dial widget enabled in
the Chaser Editor by clicking on the button.
Page 64