Product manual

Run order
Single Shot: Run thru the steps once and then stop.
Ping Pong: Run thru the steps over and over again, reversing direction at
both ends.
Pattern Select the movement pattern algorithm.
Parameters
Width: Choose the pan width (0-255)
Height: Choose the tilt height (0-255)
X Offset: Move the pattern's horizontal (pan) centerpoint (0-255)
Y Offset: Move the pattern's vertical (tilt) centerpoint (0-255)
Rotation: Rotate the pattern along its axis (0-360 degrees)
Start Offset: Where along the path the movement should start (0-360
degrees)
X Frequency: Change the Lissajous pattern's X (horizontal) frequency (0-
5)
Y Frequency: Change the Lissajous pattern's Y (vertical) frequency (0-5)
X Phase: Change the Lissajous pattern's X (horizontal) phase (0-360
degrees)
Y Phase: Change the Lissajous pattern's Y (vertical) phase (0-360
degrees)
Note: when EFX is started, it will set the intensity of all included fixtures to the preset value. That
usually means it set them full on. If you don't want this, just set the preset intensity to something
lower, perhaps 0. That way you can control intensity of the fixture using other means like VC
sliders for the intensity/dimmer channels, or by another chaser.
Page 36