Product manual

Chaser Editor
The chaser editor, as its name suggests, is used to edit chaser functions.
Controls
Chaser
name
Change the name of the chaser.
Show/Hide the Speed Dial widget, used to facilitate the Chaser parameters tuning
like Fade In, Fade Out and Hold
Start to run the Chaser to test the playback beginning from the selected step
Stop a previously started playback
When playback is active, go to the previous step in the Chaser
When playback is active, go to the next step in the Chaser
Copy the selected steps into the clipboard.
Paste the previously copied steps from clipboard to the current position selected.
If none, the steps will be appended at the end of the list
Remove the selected steps from the list and copy them into the clipboard.
Add an existing Function to the chaser, using the Select Function dialog. The
function are inserted after the currently selected step.
Remove the selected step from the chaser.
Move the selected step above/before the previous step.
Move the selected step below/after the next step.
Run
Order
Loop: Run thru the steps over and over again.
Single Shot: Run thru the steps once and then stop.
Ping Pong: Run thru the steps over and over again, reversing direction at
both ends.
Direction
Forward: Run thru the steps from start to end; 1, 2, 3...
Backward: Run thru the steps from end to start; ...3, 2, 1
Fade In
Common: Apply the same speed for all the steps in this Chaser
Per step: Apply a user defined speed for each step in this Chaser
Page 31