Product manual

fixtures
window.
Remapped
fixtures
On the right side of the window, there is a tree representing the universes,
fixtures and channels where you are going to remap your source fixtures.
Add one or more fixtures to the Remapped fixtures list. Clicking this button will
open the Add/Edit Fixtures window. Please note that once a fixture is added, it
cannot be modified, so if you need specific names or quantity, remember to do
it before adding the new fixtures
Remove the selected Fixture from the remapped fixtures list.
This is probably the most important button in the window. It allows you to
determine the connection between a source ficture and a remapped fixture. The
connections can be performed either between single channels or on whole
fixtures.
In the first case you will need to select the source channel from the source
fixtures list and a target channel from the remapped fixtures list.
In the second case you will need to select a fixture from the source fixtures list
and a target fixture from the remapped fixtures list.
Wrong selections will cause an error message to popup. For example you
cannot remap a channel to a fixture and vice-versa.
If the connection is valid, it will be represented as a line in the white area
between the source list and the remapped list.
Remove a previously created remapping connection. Wrong selections will
cause an error popup.
Remap
fixtures
names
If this is checked, a new remapping connection between fixtures will also set
the target fixture name be the same as the source fixture name.
Destination
project
name
The absolute path and name of the remapped project. For convenience, QLC+
will automatically take the original project name and will add "(remapped)" at
the end of it.
Page 24