Installation Instructions

Planning the Job
2
DMX AG™ Foundation Guide: Version 4.3
Updated: Updated September 9, 2014 (clarifications only denoted by ᵠ)
Planning the Job
Introducing DMX AG™
DMX AG™ is a dimpled plastic membrane with a flat tab on one side. To install it,
you will basically wrap it around the foundation with the flat tab at the top,
attaching the top of it to the foundation wall using special washers and nails, and
applying a ½” wide x ½” thick sealant bead between the flat tab and foundation*.
This is a simplified view:
Sealant Bead*
(Optional)
Flat tab
The raised dimples go against the
wall.
The flat tab goes at the top, 1 inch
below the grade line.
Install concrete nails and approved
washers.
Foundation wall
DMX AG™ wraps around the base
of the foundation wall. (Option)ᵠ
A properly installed and
functioning drainage
system is vital
Footing