Installation Instructions

Installing DMX AG™
DMX AG™ Foundation Guide: Version 4.3
Updated: September 2, 2014 (clarifications only denoted by ᵠ)
15
Sealing the End of the Roll
If you are not wrapping the entire foundation in DMX AG™, such as when there
is an attached garage, you need to seal the vertical ends of the DMX AG™.
Anchor the membrane to the foundation using DMX Washers™, including the
vertical open end at 6 inches* (15 cm) spacing which will receive some closing
trim. Then install DMX FlexTrim™ on the vertical edge just as you would for cut
edges in the top of the membrane.
Patching the Membrane
If you need to patch the membrane because of a tear, use an extra piece of
membrane that is at least 12 inches (30 cm) larger than the tear. Mesh the
dimples, apply a full bead of sealant* and install DMX Washers™ in the corners
of the patch.
Depending on the size of the patch, you
may need to install washers at the
approved distance spacing as in the main
body area.*