Installation Instructions

Installing DMX AG™

DMX AG™ Foundation Guide: Version 4.3

Updated: September 9, 2014 (clarifications only denoted by ᵠ)

In heavy clay soil, we recommend that you insert a third row of washers

12 inches (30 cm) below the second row of washers, with a spacing of

12” to 14” (30 cm to 35 cm)*. For DMX Quick Clips install them at a

spacing of 14” to 16” (35 cm to 40 cm)*

Insert a final row of washers approximately 12 inches (30 cm) above the

footing spaced 10 feet apart. This final row of washers will prevent the

crushed stone from getting under the membrane.

Corners

It is important to fit the membrane tightly to corners. Fasten the membrane near

the top and bottom by inserting washers at least 6 inches (15 cm) back from

outside corners and 6 inches (15 cm) from inside corners. (Fastening the

membrane too close to outside corners can cause the corner to crack.)

The use of a 2" x 4" wood stud will help form and hold the

shape of interior corners!*

Please Note:

The Illustration to the right

shows 4ft. partial sections

for illustration purposes

only. They are not

representative of a full-

sized panel of DMX

AG™.