Installation Instructions

Installing DMX AG™
7
DMX AG™ Foundation Guide: Version 4.3
Updated: September 9, 2014 (clarifications only denoted by ᵠ)
Position the DMX Washers™ in the flat tab, 6 – 8 inches* (15 cm – 20 cm)
apart, secure in place with 1 ¼ inch concrete nails.
Install DMX Washers™ or DMX Quik Clips in the dimpled section, in
accordance with the diagram below the tab, with the washers spaced 12 –
14 inches* (30 cm – 35 cm) apart and Quik Clipsᵠ at 14”-16” (35cm –
41cm) (please refer to diagram below left for washers and below-right for
Quick Clips).
Please Note:
The Illustrations shownᵠ are 4ft. partial sections for illustration purposes
only. They are not representative of a full-sized panel of DMX AG™.