Manualshelf

User guide

ManualsBrandsDMT ManualsProjectorPresenter Control
51525354555657585960
S1 User Handbook
41
4
ADVANCED CONFIGURATIONS
ADVANCED CONFIGURATIONS
AUX Buttons Box
Lock on POST & Fader Up. When enabled, the AUX button is locked if it is set to post and any
of the channels are currently routed.
Monitor Set-up
Monitor Channels:
Interlock/ Mix
Select whether the monitor channel will interlock or mix with other monitor channels.
When set to interlock, the selection of the channel will deselect another channel also set to
interlock. When set to mix, the channel will mix with other monitor channels, including any
set to interlock.
Alias
Set the text displayed in the virtual scribble pad on the main screen. Note: this feature is not
available for the PGM monitor channel.
Monitor Mute
It is possible to dim the volume of, instead of muting, the Control Room monitor output
when Control Room mute has been activated by an input channel
Metering:
Set the meter display method to either Peak Programme Meter (PPM) or Volume Unit (VU)
Button Lock:
Set which buttons, that do not form part of an input channel, are to be locked in their
current state.
Display Intensity
It is possible to adjust the brightness of the meter display and the buttons on the mixing
desk. Predetermined levels of intensity for the Meters and Buttons are independently
selected using the appropriate slide bar. The very top selects maximum intensity and the
very bottom selects the lowest intensity. For the meters the lowest intensity is o, this is
useful when using an external meter display such as the Sonifex S2-MPPT True PPM
Meter Panel.
Talkback Setup Box
Route Talkback
It is possible to congure when talkback audio should be routed to the rear talkback
connector output. This can either be permanent or only when the guest talkback button,
channel 5 CUE/PFL & TB button or channel 6 CUE/PFL & TB button is on.
Source
The talkback source is always channel 1 but the input that acts as the talkback can be set
to either Mic (Default) or Line. This is useful when using a line level input i.e. an external
microphone amplier or voice processing unit.