Operating Manual

Digital DMR and

Analog UHF/VHF Two Way Radio

SAFETY

The

Anytone AT-D578UV DMR mobile transceiver has been carefully designed to provide

you with years of safe, reliable operation. As with all electrical equipment, however, there

are a few basic precautions you should take to avoid hurting yourself or damaging the

radio:

• Read the instructions in this handbook carefully. Be sure to save it for

future reference.

• Read and follow all warning and instruction labels on the radio and

owner’s manual.

• Be sure the “PTT” key is not pressed when you do not need to transmit.

• Do not operate the radio near unshielded electrical blasting caps or in an

explosive atmosphere.

• Respect the environment conditions. The radio is designed to be used in heavy

environments, however avoid exposing it to extremely hot or cold temperature (out of the

range between –20°C to +60°C). Do not expose the transceiver to excessive vibrations as

well as dusty or rainy locations.

• Never try to disassemble or service the radio by yourself (aside from the routine

maintenance described in this handbook). It may cause damage to the radio transceiver

and void your warranty requiring extensive repair work. Always contact your local dealer

for assistance.

• Use only authorized accessories. Using non Anytone radio brand accessories may

seriously damage your handheld transceiver and void your warranty.

• Do not spill liquid of any kind into your radio. If the transceiver gets wet,

immediately dry it by a soft and clean cloth.

• Switch the radio off before you clean it.

• Be certain that your power source matches the rating listed for the supplied power cord.

If you are not sure, check with your authorized Anytone dealer.

• Avoid damaging the power cord. Do not step on or place anything on it as this could

result in a damaged charger power cord. This product complies with the requirements of

the Council Directives 89/336/EEC and 73/23/EEC on the approximation of the laws of

the member states relating to electromagnetic compatibility and low voltage.