Operating Manual

26
Digital DMR and Analog UHF/VHF Two Way Radio
SQ: You can hear the call once the channel receive matched carrier. CDT: You can hear
the call when receive matched CTCSS/DCS signal. TONE: You can hear the call when
receives a matched signaling.
C&T: You can hear the call when receives a matched CTCSS/DCS and matched
signaling.
C|T: You can hear the call when receives a matched CTCSS/DCS or.
(11)
Band Width
Choose wide band or narrow band for the analog channel.
(12)
Reverse
When this function is enabled, the RX frequency, TX frequency and CTCSS/DCS encode/
decode will be reversed.
(13)
Compander
Enable this function to reduce background noise and enhance audio
clarity, especially in long range communication.
(14)
Encryption
An analog voice inversion scrambler can be equipped.This special audio process can
offer a more condential communication.
Other radios at same frequency will receive only disordered noises.
(19)
Busy Lock
Always: Always allows transmissions
RL: Will not allow transmit when receiving matched carrier but unmatched CTCSS/DCS.
BU: Will not allow transmit when receiving matched carrier.
(21)
OWN ID
When the analog channel set up with optional signal, you can check the radio ID number
in this menu. The ID number should be set up in PC software – Analog – Analog Address
Book.
(22)
DTMF Enc
Set a DTMF ID as the default call ID for the current channel.
Press the PTT key to transmit the selected DTMF ID.
Edit the DTMF ID in Menu or with the PC programing software.
(23-24)
2Tone Enc/Dec
Set a 2Tone as the default call ID for the current channel. Press the [PTT] key to transmit
the selected 2Tone.
Edit the 2Tone in the PC programing software before it can be selected.
(25)
5Tone Enc
Set a 5Tone as the default call ID for the current channel. Press the [PTT] key to transmit
the selected 5Tone.
Edit the 5Tone in the PC programing software before it can be selected.
7.7.3 Device Info
Show the Radio ID, Radio name, model name, frequency range, rmware version and
hardware version, radio data version, latest program date, picture version, language
version, sct version and BT module version.
7.MAIN MENU FUNCTIONS