Operating Manual

12
Digital DMR and
Analog UHF/VHF Two Way Radio
Sub CH Hide T
urn on/ off the sub channel
Prior Zone Switch to Priority Zone
Program Scan
"Press the key to start the scan in VFO channel scan start and end
frequency must be programmed in CPS."
Enhance Sound
In digital channel, switch the microphone tone to normal or enhanced
mode.
LastCall Reply
In digital channel, press the key to access the last call and press
PTT to call back.
Switch ChType Switch the channel type(Analog, Digital, Ana+Dgi, Dgi+Ana)
Ranging
When the radio receives a call and the suspension time is on, press
the key programmed as" Ranging" to obtain the caller's position and
distance. (Both party need GPS positioned, or will receive only GPS
information)
Roaming
In standby, press the key programmed as "Roaming" to search and
lock on the repeater with strongest signal. (Note: After lock on a
repeater, the radio will return to last frequency only after channel
or frequency is changed. The repeater frequency list must pre-
programmed in CPS.)
CH Ranging
In standby, if the call contact type for a channel is "Single call" , press
the key programmed as " Channel Ranging" to turn on this function.
The radio will automatically start ranging function when turn to this
channel.
Max VOL Set
In standby, press the key programmed as" Max Volume", will enable
users to set the maximum RX volume.
Slot Set
Choose Slot for current channel, this function is only valid in repeater
mode.
Aprs Type Choose analog or digital Aprs Type for current channel.
Zone Select
In standby, press the programmed "Zone Select" key, it will allow you
input the zone number and then press conrm key will switch to the
zone.
A CH Mute Mute the main channel
B CH Mute Mute the sub channel
Roaming Set Enter into Roaming menu swiftly
APRS Set Enter into APRS menu swiftly
Zone Up Switch the zone upwardly
Zone Dn Switch the zone downwardly
Exit Exit the menu (only for A-D short press)
Menu Enter into the menu (only for A-D short press)
4. RADIO OVER
VIEW