Operating Manual
11
Digital DMR and
Analog UHF/VHF Two Way Radio
The top LED will help you to identify the current radio status.
It is possible to set dif
ferent functions for [P1], [P2], [P3],[P4],[P5],[P6]. A,B,C,D.
Method 1: In radio Menu - Settings - Radio Set - P1~P6, PA-PD.
Method 2: In PC software - Public - Optional Setting - Key function.
4. RADIO OVER
VIEW
4.1 Status Indications
4.2 Programmed Key
LED Indication Status
Constant Red T
ransmitting
Constant Green Analog Receiving
Constant Cyan Digital Receiving
Flashes Green Scan
Constant Orange Repeater function
OFF No Function
V
olt Check the current battery capacity voltage
Tx Power Switch the power between super high, high, middle and low power.
TalkAround Switch between Talk Around and Repeater mode
Reverse Turn on/off the frequency reverse function.
Digi Encrypt Choose the digital encryption group for digital channel
Call
In
Analog mode, send the DTMF/5TONE/2TONE encode. This
function is only valid for analog channel.
VFO / MR Switch between VFO mode and memory channel mode.
Scan Scan on/off
FM Radio FM radio on/off
Alarm Long press the key to start alarm, short press again to exit the alarm.
Record Switch Enable/disable the recording function
Record
Start/stop recording. When stop recording, the radio will remind
repeat or send the record.
SMS In digital mode, press to enter into SMS messages
Dial Start the manually dial
GPS Info Check the GPS position information
Monitor Monitor the weak signal or the signal with unmatched ID.
Main CH Switch Choose channel A or channel B as the main channel
Hot Key 1~6 Selects Hot Keys 1-6 Note: Hot key setup details on next page
Work Alone Turn on/off the work alone function.
Nuisance Delete During scanning, press the key to skip the unwanted channel
Digi Monitor In DMR mode, press the key to turn on/off digital monitor