Installation Guide

1141 INSTALLATION GUIDE | DIGITAL MONITORING PRODUCTS 3
5
TEST THE TRANSMITTER
After the 1141has been installed, test to confirm that it is communicating reliably with the panel. Use the Tech
APP™ to perform a Wireless Walk Test on the system or follow these steps to perform a Walk Test from a
keypad that is connected to the panel:
1. At the keypad, enter 8144 (WALK) and select WLS.
2. If the transmitter fails to check in at the keypad, ensure that it is wired properly and check for sources
of interference such as metal objects and electronic equipment.
ADDITIONAL INFORMATION
Replace the Batteries
Use 3.0V lithium batteries, like DMP Model CR2430, or equivalent retail models. Refer to Section 2 for battery
installation instructions. Properly dispose of all used batteries.
Sensor Reset to Clear LOBAT
1. Once the battery is replaced, a sensor reset is required at the keypad to clear the LOBAT message.
2. On an LCD keypad, press and hold 2for two seconds. On a graphic touchscreen keypad, press RESET. Enter your
user code, if required. The keypad displays SENSORS OFF followed by SENSORS ON.
Mounting
Holes
Button
LED
Figure 5: LED and Mounting Hole Locations Figure 6: Mounting with Tape
SERIAL #