Installation Guide

2 1141 INSTALLATION GUIDE | DIGITAL MONITORING PRODUCTS
MOUNT THE TRANSMITTER
When mounting the 1141, refer to Figure 5 for mounting hole locations. For simpler mounting or waterproof
installations, use double-sided tape. Refer to Figure 6. To mount the 1141 with the included screws, complete
the following steps.
1. With the cover removed, place the two supplied Phillips head screws into the mounting holes.
2. Secure the housing base to the surface.
3. Snap the transmitter cover back onto the base.
4
3
The 1141 provides a Survey LED capability to allow one person to confirm communication with the wireless
receiver or panel while the cover is removed.
1. With the cover removed, hold the transmitter in the desired location.
2. Press the button to send data to the panel and determine if communication is confirmed or faulty.
Confirmed: If communication is confirmed, for each press or release of the button, the LED blinks
immediately on and immediately o. Repeat this test to confirm five separate consecutive LED
blinks. Any indication otherwise means proper communication has not been established.
Faulty: If communication is faulty, the LED remains on for about 8 seconds or flashes multiple times
in quick succession. Relocate the transmitter or receiver until the LED confirms clear communication.
SELECT A LOCATION
A
B
C
D
PCB Supports
PCB Snaps
Serial Number Label
Housing Tab
D
A A
AA
AA
B
B
C
Figure 3: Top Cover Interior Details Figure 4: 1141 PCB