INSTALLATION GUIDE 1101 Series Wireless Univeral Transmitter
GET STARTED The 1101 Series Wireless Universal Transmitters are two‑way supervisory wireless transmitters typically used for door and window applications. The 1101E features 128‑bit AES encryption. The transmitter provides a cover tamper, magnetic reed switch, and an onboard terminal block to allow for external contact wiring. Both sets of contacts, internal and external, can be programmed to operate at the same time. This allows two independent zones to operate from one 1101.
INSTALLATION 1 Program the Panel Refer to the panel programming guide as needed. After completing each of the following steps, press CMD to advance to the next prompt. 1. At a keypad, enter 6653 (PROG) to access the Programmer Menu. 2. For an 1101E, use the two steps below and then continue to step 3. Otherwise, go to step 3. ▶ Go to SYSTEM OPTIONS. At 1100 ENCRYPTION, select ALL to only add encrypted wireless devices to the system.
3 Use the LED Survey to Select a Location The transmitter provides a Survey LED capability to allow one person to confirm communication with the wireless receiver or panel while the cover is removed. 1. With the cover removed, hold the transmitter in the exact desired location. 2. Press the tamper switch to send data to the panel and determine if communication is confirmed or faulty.
Wire External Contacts (Optional) Refer to Zone Information in the appropriate panel programming guide for more information. DMP recommends using 18 or 22 AWG unshielded wire for contact connections. Do not use twisted pair or shielded wire. Refer to Figure 6 when wiring external contacts. 1. Use a flathead screwdriver to loosen the two external contact terminal screws. 2. Insert external contact wiring into the 1101 terminal block and tighten the screws. 3.
SPECIFICATIONS Battery Life Expectancy 5 Years (normal operation) Type 3.0 V lithium CR123A Frequency Frequency Range 905‑924 MHz Dimensions Transmitter Case 3.3 L x 1.6 W x 0.9 H in. Transmitter Base 3.3 L x 1.6 W x 0.1 H in. Magnet Housing 1.5 L x 0.5 W x 0.7 H in. Magnet Spacer 1.5 L x 0.5 W x 0.1 H in.
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made by the user and not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
