Installation guide

INSTALLATION GUIDE
738Z Z-Wave Interface Module
Description
The 738Z Z-Wave Interface Module provides communication with up to
232 Z-Wave devices such as light controls, door locks, and thermostats
for residential or small commercial installations. The 738Z easily
connects to the panel’s keypad bus and unies the control of home
electronics using an integrated wireless network. Now, devices can
be remote controlled from an Apple iPAD/iPhone and Android using
the DMP Virtual Keypad™ application or from any cell devices using
MyAccess™ text commands.
Compatibility
• XT30/XT50 Series panels using software version 109 with Level F hardware support up to 32 Z-Wave devices.
• XT30/XT50 Series panels using software version 110 with Level G hardware support up to 232 Z-Wave devices.
• XTL Series panels using software version 109 with Level D hardware when operating from AC power support up
to 32 Z Wave devices. Battery only operation is not supported.
• XTLC panels using software version 110 with Level E hardware support up to 232 Z-Wave devices.
• XTLN/XTLN-WiFi panels.
• XR150/XR350/XR550 Series panels.
• Mobile applications: MyAccess™ and Virtual Keypad™ App.
What is Included
The 738Z module includes the following items:
• One Model 738Z with housing
• Hardware pack
Installing the 738Z
Selecting a Location
A location should be selected that allows communication to
Z-wave devices. The 738Z complies with the Z-Wave standard
of open-air, line of sight transmission distances of 65 feet to
the rst device. The Z-Wave Light Module acts as a repeater
to create more possible transmission routes.
Installing the 738Z
The 738Z ships installed in a decorative, high-impact plastic
housing that mounts directly to walls, backboards, or other at surfaces. For easy installation, the 738Z housing
back and both ends have wire entrances for the four wire connection to the XT panel keypad bus or XTL PROG
connector shown to the right.
To connect the wiring of the 738Z to the PROG header of the XTL series panel,
use the PC-0140 Connector Assembly for connection of a Model 300 harness.
When used with the XTLC panel, the 738Z only operates when AC power is
present but is not supported during battery only operation.
Install the module away from large metal objects. Mounting the module on or near metal surfaces impairs
performance.
Programming the Panel
The 738Z Z-Wave module is programmed from the panel’s user menu Z-Wave Setup. When possible, have the Z-Wave
device near the 738Z during setup and programming.
LED Operation
Three LEDs ash to display operation and activity.
• PTX Green LED - Data is being sent to the panel.
• ZTX Green LED - Data is being sent to Z-Wave devices.
• ZRX Yellow LED - Data is being received from Z-Wave devices.
To
Keypad
Bus
Living Room
Foyer
Kitchen
Dining
Oce
Garage
= Z-Wave Light Module Device
Control
Panel with
738Z
Model 300
Harness to 738Z
PROG J5
PC-0140 Assembly
XTL PCB