User guide

42 XTL Series User Guide Appendix C
Appendix C
User’s Guide
This section of the user’s guide provides information on using the XTL Series card read capability if enabled for your system. The card
reader is located under the keypad logo. The keypad displays for All/Perimeter or Home/Away operation are dependent on how your
keypad was programmed by your alarm dealer.
There are two different operating modes: Arming and Disarming, and Entry Delay. All of the examples below assume that your system
requires a user code to arm and disarm the protection.
ARMING AND DISARMING AN ALL/PERIMETER SYSTEM
Press COMMAND. The keypad displays PERIM ALL (when arming) or DISARM?. Press the Select key under the
desired option. The keypad displays ENTER CODE: -.
Present your card to the keypad logo. Once the system validates the card, if you choose PERIM, only the
perimeter arms. If you choose ALL, both areas arm. If programmed, ALL is automatically chosen for you after a
short delay. All armed areas disarm automatically.
ARMING AND DISARMING A HOME/AWAY SYSTEM
Present your card to the keypad logo. If the system is armed, once the system
validates the card, all areas are disarmed and the keypad displays ALL SYSTEM OFF.
If the system is disarmed when you present your card, once the system validates the
card, HOME SLEEP AWAY displays. You can manually press the Select key under the
desired option or after short time all areas automatically arm in the AWAY mode.
PERIM ALL
DISARM?
or
ABC SECURITY
HOME SLEEP AWAY