User guide

User Menu XTL Series User Guide 29
The table below lists system functions users are allowed to access
based on the authority level assigned to their codes at the time
they are added to the system.
User Menu Option Standard Master
Door Access Y Y
Arm and Disarm Y Y
Alarm Silence Y Y
User Checkin Y Y
Zone Activity Check Y Y
Sensor Reset Y Y
Outputs On/Off Y Y
Favorites Y Y
Z-Wave Setup Y
Bypass Zones Y Y
Zone Monitor Y Y
System Test Y Y
User Codes Y
Schedules Y
Extend Y Y
Set Time Y
Display Events Y Y
Service Request? Y
Adding User codes
User Code Level: Master only.
1. Access the User Menu.
2. Press the COMMAND key until USER CODES? displays.
3. Press any Select key.
The keypad displays ADD DEL CHG SEND.
4. Select ADD to add a new user code.
5. At the USER NUMBER: — prompt, enter a user number and
press COMMAND.
6. The displays changes to CODE NO:. Enter the four-digit
user code and press COMMAND.
This is the number the user enters each time they arm,
disarm, or make changes to the system.
If the code you entered is already in use, or is a code used
internally by the system, the keypad displays ALREADY IN
USE. You must enter a different 4-digit user code.
7. A 16-character name may be entered to identify the user.
Press any top row key to clear the current text “user name”.
You may then enter the new name. After entering the name
press COMMAND. See Entering Names in Appendix C.
8. The display changes to MASTER? NO YES.
9. Select YES to make the user code a Master user. Select NO
to make the user code a Standard user. The following user
code options can then be selected:
9a. TEMP CODE NO YES.
Select NO to make this a permanent user code.
Select YES to make this a temporary code. The keypad
displays TEMP DAYS: - . Enter the number of days
(1 to 250) that the temporary use code can operate.
Default is seven days. Temporary users are deleted
from the system at 12:00 AM on the last day. You can
delete a Temporary user code at any time before the
programmed period ends.
9b. AREAS: (Displays in Area systems only).
Enter the area numbers where this user is to have access.
For example: if you want this user to only have access to
areas 1 and 2, enter the numbers 1 and 2.
Once the correct area numbers display, press COMMAND.
9c. ARM ONLY NO YES.
Select NO to allow this user to arm and disarm the
system and access all Standard level functions in the
User Menu.