User guide

20 XTL Series User Guide User Menu

Sensor Reset

User Code Level: Master or Standard.

Function: Clears Fire and Supervisory zone alarms and trouble

keypad displays. Sensor Reset also clears low battery displays from

wireless sensors that have restored.

Make sure all smoke is cleared from around the area of the smoke

detectors before performing a Sensor Reset to prevent the alarm

from occurring again.

Resetting the Sensors

1. Access the User Menu.

2. When SENSOR RESET? displays, press any Select key. The

keypad displays SENSORS OFFforvesecondsfollowedby

SENSORS ON.

3. The keypad returns to the status display.

Sensor (Fire) Reset Shortcut Key

All Systems — Press 2 for 2 seconds, then enter your user code if

required, to reset the system.

Outputs On Off

User Code Level: Master or Standard.

Function: Allows you to turn the system outputs on and off.

This function is used to individually turn your system outputs on

and off. Your system may use these outputs to control interior and

exterior lighting, or heating, air conditioning, or other appliances.

The system output names and numbers are located in the System

Setup section at the back of this guide.

Turning the Outputs On and Off

1. Access the User Menu.

2. Press the COMMAND key until OUTPUTS ON/OFF? displays.

3. Press any Select key.

4. The keypad displays OUTPUT: - ON OFF.

5. Enter the output number you want to turn on or off. The

output number appears in the display.

6. With the output number displayed, Select ON or OFF. The

output is then turned on or off, depending on your selection,

and remains in that state until you change it.

7. The system automatically removes the output number and a

new output number can be entered. Refer back to step 5.

To exit the Output menu option, press the Back Arrow key until you

return to the keypad Status List.

Favorite

User Code Level: Master or Standard.

Allows you to activate a Z-Wave Favorite. Z-Wave devices can

be grouped together to create Favorites. Favorites can only be

activated, or turned on. A separate Favorite must be created to

change the conditions set by the rst Favorite.  For a complete