User guide

User Menu XTL Series User Guide 19
User Check-in
User Code Level: Master or Standard.
Function: This feature allows you to monitor the arrival of children
from school or employees to work by having a special Check-in
Report sent to your email address or cell phone if programmed.
Appendix D describes the Email/Cell Phone option.
Sending a Check-in Report
1. After disarming the system, access the User Menu.
2. At the USER CHECKIN? display, press any Select key. The
keypad displays USER CHECKIN: 22 (22 = user number).
3. The panel sends the Check-in Report containing your
account number and user number to the email address or
cell phone number.
Check-in (Latch Key) Report Shortcut Key
All Systems — Press 4 for 2 seconds, then enter your user code to
send a Check-in Report.
Zone Activity Check
User Code Level: Master or Standard.
Function: Your security system may be pre-programmed at
installation for the Zone Activity Check feature allowing you to
monitor a person for non-activity.
When no activity is detected for the programmed time period, your
keypad sounds a steady tone for a set period of time and displays
PRESS ANY KEY. Pressing any key on the keypad, before the steady
tone stops, prevents your system from sending a “User Activity
Not Detected” report to the central station. Pressing the key also
restarts the zone activity timer.
This could be used for a person living alone to detect when they
have not moved about to trip a disarmed zone within a programmed
period of time. This feature is optional.
Note: The Zone Activity Check is disabled when a schedule is
activated to allow for sleeping hours and is automatically enabled
when an area is disarmed.
Selecting Zone Activity Check
1. At the ACTIVITY CHECK? display, press any Select key. The
keypad displays ENABLE? NO YES. The default is YES.
2. When YES is selected, the keypad displays CHECK ENABLED
for four seconds and then sends the Activity Check Enabled
message to the central station.
3. When NO is selected, the keypad displays CHECK DISABLED
for four seconds and then sends the Activity Check Disabled
message to the central station.