Specifications

Check-in Table IP Address: The optional SCS-CTM Check-in Table Manager software is used to

backup the records of supervised network accounts on up to 32 different SCS-104 line cards. Use SCS-

CTM to repopulate the list of supervised network accounts when one SCS-104 or SCS-101 line card is

replaced by another SCS-104 or SCS-101. Additionally, the list of supervised network accounts used by

an SCS-104 or SCS-101 on a primary receiver can be mirrored by the SCS-CTM for use by an SCS-104

or SCS-101 card on a second receiver. Refer to the SCS-CTM User’s Guide (LT-0940).

Note: The list of supervised network accounts on an SCS-104 line card is automatically

populated as each panel sends its supervisory check-in message to the SCS-104 line card.

Enter the IP address for the computer where the SCS-CTM Check-in Table Manager software is

installed. When no SCS-CTM software is installed, leave the IP address set to 000.000.000.000.

Check-in Table Port: Enter the IP port used to communicate Check-In Table messages to the

SCS-CTM Check-in Table Manager program. Valid range is 1 to 65,535. Default is 2005.

Check-in Table ID: Enter the table ID number to be used by the SCS-CTM Check-in Table Manager to

identify the check-in table. Valid range is 1 to 255. Default is 1.

Send: Click Send to send the Receiver Line Card programming to the SCS-1R.

Program > Receiver Hosts

This section assigns programming to the Receiver Host that is connected to the

SCS-1R.

Connect the host computer to the Host Output port on the back of the SCS-1R

Receiver.

Note: Before continuing, click on the Retrieve button to import the current receiver

information.