Specifications

© 2015 Digital Monitoring Products
Before using Remote Link, you should read and be familiar with the following documents:
Command Processor Programming and User Guides: There is a Programming, Installation, and Users
Guide for each DMP control panel that fully details the various programming options and panel
operation. There are also programming and installation guides for the hardware components that you
may use to connect to alarm panels and to take full advantage of optional features.
You may also refer to the manuals for any other equipment that is being used as part of the system.
For a complete list of manuals, or to order a manual, call DMP Customer Service at 1-800-641-4282 or
contact your regional DMP Sales Representative.
You may also visit our document library at the DMP Web site at http://buy.dmp.com.
Before installing Remote Link, make sure that your computer hardware meets these minimum
specifications listed in the table below.
Operating System
Minimum Requirements
Windows 2000
Pentium 150 mHz
64 MB RAM
Windows XP
Pentium II 300 mHz
128 MB RAM
Windows Vista
1 GHz
1 GB RAM (32-bit)
16 GB hard disk space available
DirectX 9 Graphics
Windows 7
1 GHz
1 GB RAM (32-bit)
16 GB hard disk space available
DirectX 9 Graphics
Windows Server 2008 R2
1 GHz
1 GB RAM (32-bit)
16 GB hard disk space available
DirectX 9 Graphics
Note: You need to have Administrator Authority or select 'Run as Administrator' to install
Remote Link software.