Specifications

3. Start Remote Link and create or open the panel account that matches the panel to be updated.

4. Set the Connection Information Type to Direct with a baud rate of 38400 and choose the

appropriate COM port. Click OK to apply changes.

5. Select Panel>Remote Update, then select the correct RU file for the XTL/XTLN/XTLN-WiFi panel

model.

6. Press and hold down both of the Reset and Load buttons on the XTL/XTLN/XTLN-WiFi panel.

Release the Reset button first, followed by the Load button. If the TX and RX LEDs are solid lights,

then click <Update> in Remote Link. If not, repeat this step.

7. After the software version is updated, press and release the Reset button and remove the 399

cable.

8. If using a wired keypad, plug the keypad back into the panel.

9. Set the Connection Information Type back to Cellular or Network and click OK to apply changes.

Performing the Update (SCS-104 Receiver Line Cards)

Use the following steps to perform the SCS-104 update:

1. Remove the SCS-104 Line Card from the SCS-1R Receiver.

2. Connect a Model 399 Programming Cable to the PROG header (J8) on the line card and to a

computer with Remote Link.

3. Place a shorting clip across the 2 pins of the LOAD (J18) header.

4. Reinstall the SCS-104 Line Card into the SCS-1R Receiver to power up line card.

5. Open Remote Link (version 1.61 or higher) and select System > Remote Update from the drop-

down menu.

6. In the Remote Update window, use the browse button to find the SCS104.RU software update

file on your computer's hard drive. Remote Link automatically recognizes the update for the

SCS-104 and allows you to select the COM port where the line card is connected.

7. Select Update. After the update is complete, remove the SCS-104 from the receiver and

disconnect the 399 cable and remove the shorting clip from the LOAD header. Reinstall the Line

Card to begin normal operation.

Panel > Feature U pgrade

The XR2500F, XR500 Series, and XR150/XR350/XR550 Series, panels have the ability to perform a

remote feature upgrade using Remote Link. This remote Feature Upgrade capability allows you to

enable additional features on panels without requiring a trip to the site.

Purchasing Feature Upgrades

If you would like to purchase a feature upgrade, the authorized purchasing agent for your company

may contact DMP Customer Service in writing via e-mail or fax. Include the upgrade feature(s) to

enable and the panel serial number(s) on the request. A separate feature key is issued for each panel.

The feature key only enables the requested feature on the specified panel.

The panel serial number can be located in several different ways:

Printed on a label located on the right side of the XR500 PCB.

Using panel diagnostics. See the Appendix in the XR500 Series Programming Guide (LT-0679).

Using Remote Link (version 1.18 or higher)