Specifications

The software updates are posted to the Dealer Direct section of the DMP Web site at www.dmp.com.

Follow the directions on the Web site to download the update to your computer hard drive.

Note: Be sure to save the update in a location on your computer hard drive you will remember.

Performing the Update (XR2500F, XR500 Series, XR100 Series, and XR150/XR350/XR550

Series)

To perform a remote panel update, connect to the panel to be updated. After successfully connecting,

select Panel > Remote Update from the drop-down menu. In the Remote Update window, use the

browse button to locate the firmware update RU file on your computer hard drive and select Update.

Performing the Update (XT30 Series, XT50 Series)

The XT Series panel software can be updated via the panel's programming (PROG) header. To update

the panel with a new software version, complete the following steps:

1. Place a jumper across the Reset (J16) header and then remove the yellow and green wires from

keypad bus terminals 8 and 9.

2. Connect a DMP 399 Cable from the J8 Programming Header to the serial COM port of the PC

operating Remote Link and containing the XT RU file. Requires Remote Link 1.43 or higher.

3. Start Remote Link and create or open the panel account that matches the panel to be updated.

4. Set the Connection Information Type to Direct with a baud rate of 38400 and choose the

appropriate COM port.

5. Select Panel>Remote Update, then select the correct RU file for the XT panel model.

6. While placing a short across the LOAD (J18) header, remove the jumper from the Reset (J16)

header. Then remove the short from the LOAD header and click <Update> in Remote Link.

7. After the software version is updated, place the jumper across Reset (J16) then remove the

399 cable.

8. Replace the yellow and green wires to terminals 8 and 9.

9. Remove Reset (J16) jumper to resume normal panel operation.

Performing the Update (XTL, XTLN, XTLN-WiFi)

The XTL/XTLN/XTLN-WiFi Series panel software can be updated via the panel's programming (PROG)

header. To update the panel with a new software version, complete the following steps:

1. If using a wired keypad, unplug the keypad from the panel.

2. Connect a DMP 399 Cable from the J8 Programming Header to the serial COM port of the PC

operating Remote Link and containing the XTL/XTLN/XTLN-WiFi RU file.