Specifications

System > Configure > Remote Link > Mo dules Tab

Host M onitoring (Must have an additional module to use)

Host Monitoring: Select Host Monitoring to enable the module to receive signals from network

enabled panels.

UDP Port: Enter the data network UDP port number through which the module will use to monitor for

incoming alarm signals. 2001 is the default port.

Direct Monitoring (Must have an additional module to use)

COM Port: Select the COM port that is connected to your panel.

Baud Rate: Set the baud rate to 9600.

Command Center (Must have an additional module to use)

Track Armed Status: Select Track Armed Status to allow the Command Center to display the armed/

disarmed status of all monitored accounts.

Note: All XT Series, CellComSL, XR100, XR500, XR150/XR350/XR550 Series can track the Arm/

Disarm status of the panel, however, for the XR200 Series, only the XR200 (version 110) and

XR200-485 (version 204) have this capability.