Specifications

© 2015 Digital Monitoring Products
System > Configure > Remote Link > Other Tab
Time Zone: Under the Other tab, select the appropriate time zone where your Remote Link computer
is located from the drop-down menu. If your time zone is not listed, enter a time zone value according
to the table of time zones.
Enable Debug Logging: Select the Enable Debug Logging to allow all communication between the
panel, receiver, and Remote Link to be saved in the debug table for diagnostic purposes. Uncheck the
box to disable this function. When the box is unchecked, you will not be able to view communication in
the diagnostics screen. By default, Enable Debug Logging is selected.
Enable Alarm/Event Monitoring: Select Enable Alarm/Event Monitoring to allow Remote Link to
display panel alarms and system event messages in the Alarm List. Uncheck this option when Remote
Link is used for programming purposes with a shared database without displaying panel messages. By
default, Enable Alarm/Event Monitoring is checked and should be checked when using the Alarm/
Event Monitoring mode.
Logging Threshold: Select the type of issue to log into the Remote Link error log file. By default,
Logging Threshold is set to Warning. All messages with a severity equal to or greater than the
threshold setting will be logged.
Debug: Detailed information that does not indicate an error, similar to communication strings. This
setting greatly increases the size of the log file.