Specifications

page 14.

This section gives you basic information on how to connect your Remote Link computer to your

communication line. For further information, refer to the installation guide that you received with

your hardware or visit the DMP website at http: //www.dmp.com

Direct Cable Connection: LT-0355

SCS-105 Single Line Receiver: LT-0153

SCS-1R Receiver: LT-1037

Network Device Connection: iCOM/iCOM-E: LT-0587, iCOMsl: LT-0631

Direct Cable Connection

The direct cable connection allows you to connect a single XR500 Series, XR2500F panel to a computer

with a cable no more than 50-feet long. This is the simplest type of connection. The kit needed (462N-

DC Network Interface Card with cable) for a direct cable connection is available from your vendor

representative.

For XT Series or XR100 Series panels, the Model 399 cable offers panel to Laptop connection for

programming or to flash update the panel. The Model 399 cable 4-wire header plugs onto the panel J22

header. The DB-9 end connects to the Laptop.

For XR100 Series panels, before programming or starting a flash update, make sure the J23 jumper is

set to the top position next to the letter "R" and the panel has been reset. Refer to the XR100 Series

Installation Guide (LT-0899) for detailed information.

For XT Series Panels, before connecting the Model 399 cable for a flash update, place a jumper across

the Reset (J16) header and then remove the yellow and green wires from keypad bus terminals 8 and

9. Refer to the XT30/XT50 Series Installation Guide (LT-0980) for detailed information.

SCS-1 or SCS-1R Receiver - The SCS-1 or SCS-1R Receiver is a rack-mountable receiver that

accepts up to five line cards.

Complete instructions for the SCS-1 or SCS-1R Receiver are packaged with the SCS-1 or SCS-1R

Receiver. The SCS-1 Installation/User Guide (LT-0065), The SCS-1R Installation/User Guide (LT-

1037), and the SCS-1R Product Specification (LT-0012) can be found in the document library at the

DMP Web site at http://buy.dmp.com.

System > Configure > SCS-1 System

The SCS-1 System Configuration window allows you to configure Remote Link to communicate through

an attached receiver. If you are communicating with panels through either an SCS-1, SCS-1R or SCS-

105 receiver, follow the instructions below.

Enter the SCS-1 System Configuration window by selecting System > Configure > SCS-1 System. You

also configure SCS-105 Single Line Receivers in this window.

System Number: If your central station has more than one SCS-1, SCS-1R or SCS-105 receiver, enter

the number of the appropriate receiver in the System Number field.

Company Name: Enter the name of the company operating the central station receiver.