Specifications

© 2015 Digital Monitoring Products
The Group Send Status
window displays a list of the
panels Remote Link
attempted to connect to when
the group send process was
started. Any communications
that fail are listed first.
In the example, the XR500N
panel with account number
4321 failed to update. The
XR500E panel with account
number 3848 successfully
updated.
To resend all accounts that
failed to update, press Resend
Failed. To send a single
account, select that account
and press Send Selected.
After the resend process, the
Status column in the Group Send Status window updates.
In order to use Remote Link you must have a connection that will let your computer communicate with
the alarm panel. There are six basic types of connection available:
Direct cable
SCS-105, SCS-1 or SCS-1R Receiver phone line connection
iCOM Network Alarm Router, iCOM-E Encrypted Network Alarm Router or iCOMSL Network Alarm
Router
DMP 462FM Fast Modem or 2400 baud panel dialer
462N Interface Card
XR150/XR350/XR550 with Network or Encryption, XR500N, XR500E, XR2500F, or XR100N on-
board Ethernet connector
XT30, XT50 on-board Ethernet connector
Refer to the installation guides that came with your product for information on hardware
connections and configuration.
For a complete list of manuals, or to order a manual, call DMP Customer Service at 1-800-641-
4282 or contact your regional DMP Sales Representative.
You may also visit our document library at the DMP IQ Web site at http://buy.dmp.com.
Connecting to a Panel
In order to use Remote Link you must have a connection that allows your computer to communicate
with the alarm panel. For software connection information, see the Connecting to a Panel section on