Specifications

© 2015 Digital Monitoring Products
dialer. This allows you to connect to the panel with a standard computer modem.
Note: These are for the local computer modem.
Baud Rate: Set the baud rate for Remote Link to communicate with the computer modem. Default
setting is 9600.
Flow Control: Select the flow control option recommended by your modem manufacturer. The default
setting is Hardware. If the modem does not operate correctly with the default Hardware setting, select
ON/OFF, also known as software flow control. If neither setting operates correctly, select None. For
more information see your modem documentation.
Tone Dial: Check this box if you wish to tone dial. Leave this box empty for pulse dial.
System > Configure > R emote Link > Modem T ab
General Options
Dial Time Out: Enter the length of time Remote Link will wait for the XR500 Series or XR150/XR350/
XR550 Series panel or 462FM to pick up. Enter a range from 1 to 255 seconds. The default is 60
seconds. You may need to extend the Dial Time Out depending on the 462FM's programmed Ring
Count. Extend the Dial Time Out about 10 seconds for each ring programmed in the Ring Count.
Modem Initialization String: If an initialization string is required for the modem communicating to
the panel, enter the setup string here. The string can be up to 32 characters long.
Special Initialization String: The special initialization string required to ensure the modem
communicates consistently at a slower baud rate is entered here. The string can be up to 32
characters long.
Note: Only one initialization string can be used. Select the correct one for your operation. See
Panel Information.