Specifications

number should correlate with the number of digits of the zones that report to the panel.

For example, the XR200 panel has zones 1 through 299. So you would want to set this to 3 to allow all

299 zones to report.

SCS-1 or SCS-1R Receivers: This number must match the zone number programmed in the

Host setup programming on the receiver.

CS-105 Receivers: Use 3 for SCS-105 Single Line Receivers.

User #: Select the number of digits used to report a user number. Select 3 to allow 999 users.

SCS-1 or SCS-1R Receivers: This number must match the User number programmed in the

Host setup programming on the receiver.

SCS-105 Receivers: Use 3 for SCS-105 Single Line Receivers.

(Must have an additional m odule to U se)

System > Configure > Remote Link > Receiver Tab

The Default Receiver field allows you to assign a receiver number for Host/Net Monitoring. Enter a

number from 1 to 9 that represents Host/Net Monitoring. This is to help you distinguish between

alarms received in the Host mode and those received from another type of receiver, such as an SCS-1

or SCS-1R Receiver.

If you do not enter a number in this field, the receiver number for host monitored accounts will default

to 1 (one).