Specifications

© 2015 Digital Monitoring Products
System > Configure > R emote Link > R ece iver T ab
General Options
Areas: Select which reporting format Remote Link will use to communicate with panels.
Bin: 2-character hexadecimal mode. Use this mode with SCS-105 Receivers.
Dec: 2-character decimal mode. Select this mode if the SCS-1 or SCS-1R Receiver has been
programmed to require Dec mode.
Start Character: When the SCS-1 or SCS-1R Receiver has a line configured to attach to a data
network, set the Start Character to the same as the character programmed in the SCS-1 LSU Host
Configuration. The default setting is STX. Refer to your SCS-1 Receiver Installation and User's Guide
(LT-0065) or SCS-1R Receiver Installation Guide (LT-0717).
None: Use this option when the SCS-1 or SCS-1R Receiver is not connected to a data network.
STX: Use this option when the SCS-1 or SCS-1R Receiver is configured to use STX.
Other: If the SCS-1 or SCS-1R Receiver is set to a different Start Character than the available
options, select Other and enter that Start Character in the field immediately to the right of the
Start Character menu.
CRC: Check this box if the SCS-1 or SCS-1R Receiver CRC option in the LSU Host Options is set to
YES.
Sequence Numbers: Check this box if the Sequence Numbers option in the SCS-1 or SCS-1R Receiver
LSU Host Setup is set to YES.
System > Configure > R emote Link > R ece iver T ab
Receiver Lengths
Line #: This field designates how many digits the receiver will use for the line number used by the
panel to communicate a message.
CS-1 or SCS-1R Receivers: Select 1 to allow single-digit numbers or 2 to allow two-digit line
numbers. Select 0 to allow no line numbers.
SCS-105 Receivers: Always select 0 for SCS-105 Single Line Receivers.
Zone #: This field determines how many digits may be assigned to report a zone number. This