Specifications

© 2015 Digital Monitoring Products
FA Series Wireless Options (XR500 Series)
These options only apply when using an FA400-DMP
Remote Receiver through a DMP 472 FA Series
900MHz Interface Card. Refer to the XR500 Series
Programming Guide (LT-0679), XR200 Programming
Guide (LT-0196), or XR200-485 Programming Guide
(LT-0499) as needed for wireless operation.
Note: For XR500 Series panels set the House
Code to 99 to enable FA Series Wireless.
Refer to System Options.
Wireless: Select this field if the zone you are
programming is FA Series wireless. These options only apply when using an FA400-DMP Remote
Receiver through a DMP 472 FA Series 900MHz Interface Card. Refer to the specific panel
programming guide as needed for wireless operation.
Check-in Time: Select the check-in time required for the wireless zone. The wireless transmitter must
check-in at least once during this time or a missing condition is indicated for that zone. Select 3, 15,
or 60 minutes. Select None for unsupervised operation. Default is 60 minutes.
Note: When the panel is reset or a receiver is installed or powered down and powered up, or
Remote Link disconnects, the supervision time restarts for all wireless zones.
Internal Contact: Select this field to use an internal contact on the wireless transmitter. Leave this
box empty to use an external contact.
End-of-Line Resistor: Select this field to supervise an external contact connected to the wireless
transmitter. Leave this box empty if you are not installing an End-of-Line resistor.
Normally Open: Select this field if the external contact connected to the wireless transmitter is a
normally open (N/O) type. Leave this box empty if the external contact connected to the wireless
transmitter is a normally closed (N/C) type.
Program > Zo ne Informatio n > Advanced Tab