Specifications

Note: When any wireless input zone for a particular address is programmed

(Ex: 11-14 = Addr 1 on the Keypad Bus or 586 on an XR500 Series or XR100

Series LX-Bus), the DMP receiver responds to the panel for this address.

Other devices, such as keypads or hardwired zone expanders, cannot use this

address. Zones connected directly to the panel cannot be wireless.

Disarm /Disable

Select this option to disable the zone

tripped message (short) to the 1100X Series

Receiver from the 1126 PIR transmitter

during the disarmed period. When

disabled, the 1126 only sends supervision,

tamper and low battery messages during the

disarmed period to extend the transmitter

battery life. Select NO to always send zone

tripped messages in addition to supervision,

tamper and low battery. Default is

checked.

Wireless P IR P ulse Count

Select the number of infrared pulse counts (2 or 4) the 1126 PIR will use before

sending a short message to the 1100X Series Receiver. The first infrared pulse starts

a timer and count. If no additional infrared pulses occur in 25 seconds, the timer

and count are reset. Default is 4.

Wireless P IR Sensitivity

Select the sensitivity setting for the 1126 PIR. Selecting LOW sets the 1126 to

operate at 75% sensitivity for installations in harsh environments. Selecting HIGH

sets the PIR to maximum sensitivity. Default is LOW.