Specifications

System > Configure > Remote Link > Receiver Tab

Communications Options

COM Port: Select the communications port connected to the receiver from the drop-down menu. The

SCS-1R can be configured when using the SCS-150 Processor Board.

Be careful to select a setting that does not interfere with your mouse, modem, or any other device on

your computer. The COM port cannot be used for any other purpose while Remote Link is running.

Baud rate: Set your baud rate to the same setting as your receiver. The default setting is 9600 baud.

If you are using an SCS-1 Receiver Version 812 or SCS-1R to access your alarm panels, you may set

your baud rate to 19200. The baud rate set here must also be set in the SCS-1 Receiver. See LT-0065

for more information about configuring the SCS-1 Receiver or LT-0717 for the SCS-1R Receiver. If you

are using an SCS-105 or SCS-1R/SCS-150 Receiver to access your alarm panels, set your baud rate to

9600.

Dial Out Line #: This number refers to which line card that your current receiver will use to dial out.

SCS-1 or SCS-1R (using SCS-1062): Select 1-5

SCS-1R/150 (using SCS-150): Select 1-8

SCS-105: Set this value to 1.

Tone Dial: Check this box if you wish to tone dial. Leave this box empty for pulse dial.

Note: The SCS-1 or SCS-1R will always pulse dial, regardless of this setting.