Specifications

© 2015 Digital Monitoring Products
at 8 second intervals until the last 10 seconds when annunciation is at 3 second intervals.
The exit delay can be from 30 to 250 seconds. Default is 60 seconds.
During Exit Delay, if an exit zone trips, then restores, and trips again, the Exit Delay timer
restarts. This restart can occur only once.
Burglary Bell Output : Enter the output number that is turned on any time a Burglary type zone
in this partition goes into alarm. The output is turned off when you disarm the area where the alarm
occurred and no other Burglary type zones are in alarm. The Burglary Bell Output can also be turned off
at the keypad using the Alarm Silence option in the User Menu or by entering a user code with the
authority to silence alarms. The duration of the bell output follows the time entered in the Bell Cutoff
Time field in the Output Options window.
Early Morning A mbush (XR 150/XR350/XR550 with Network and XR 500
with Network only) : Enter the number of minutes delay, from 1 to 15, before a silent alarm
(Early Morning Ambush S33 report) is sent to the central station using the account number of area 1.
Enter 0 (zero) to disable this option.
Open /Close R eports : Allows the panel to send an opening report to the receiver whenever an
area within the partition is disarmed. A closing report is also sent to the receiver when any area
within the partition is armed.
Closing Check : Select the Closing Check box to have the panel verify that all areas in this
partition have been armed after a schedule expires.
Closing Code : Select the Closing Code box to require a user code entry when arming the system
at a keypad.
A ny Bypass : Allows zones to be bypassed without a code during the arming sequence. A code is
always required to use the Bypass Zones option from the User Menu on the keypad.
A rea Schedules : Allows each area in this partition to have its own arming and disarming
schedules. Leaving this box empty provides one set of arming and disarming schedules for each
partition.
Configuring Area Information
A rea: Assign a number to the area you are programming.
A rea Nam e: Assign a name up to 16 characters long for the area you are programming. Only
systems programmed for Area arming have this option available.
Note: XR150/XR350/XR550 Series and XR100/XR500 Series Version 205 or higher accept
names up to 32 characters. On an XR150/XR350/XR550 Series or XR100/XR500 Series panel