Specifications

© 2015 Digital Monitoring Products
41 to 44 - Fast response time wireless outputs (activates within 1 second)
F1 to F20 - Activate Z-Wave Favorites
XR100 Series, XR150 Series
1 to 6
450 to 474 - Slow response time wireless outputs (activates within 15 seconds)
480 to 499 - Fast response time wireless outputs (activates within 1 second)
500 to 599 - LX-Bus output
D01 to D08 - Keypad door strike relay for addresses 1-16
G01 to G20 - Output group
XR350
1 to 6
450 to 474 - Slow response time wireless outputs (activates within 15 seconds)
480 to 499 - Fast response time wireless outputs (activates within 1 second)
500 to 799 - LX-Bus output (XR350)
D01 to D16 - Keypad door strike relay for addresses 1-16 (XR350/XR550)
F1 to F20 - Activate Z-Wave Favorites
G01 to G20 - Output group
XR500 Series, XR550 Series, XR2500F
1 to 6
450 to 474 - Slow response time wireless outputs (activates within 15 seconds)
480 to 499 - Fast response time wireless outputs (activates within 1 second)
500 to 999 - LX-Bus output
D01 to D16 - Keypad door strike relay for addresses 1-16
G01 to G20 - Output group
XR200, XR200-485(B), XR2400F
1 to 10
100 to 299 - LX-Bus output
Output Name: Enter the name you wish to assign to a specific output. An output name may be up to
16 characters long.
Note: XR150/XR350/XR550 Series and XR100/XR500 Series Version 205 or higher accept
names up to 32 character.
Real-time Status (XR150/XR350/XR550 Series and XR100/XR500 Series Version 203 or
higher): If selected, this allows Real-Time Status reports, such as Output ON, OFF, PULSE, or
TEMPORAL to be sent to the PC Log computer to monitor zones, doors, and outputs by reporting
status changes.
Serial Number: Enter the eight-digit serial number found on the wireless output. The serial number
must be between 15000000 and 15999999 and cannot contain any non-numeric characters. A panel
cannot have two wireless outputs with the same serial number. Each wireless output programmed for a
specific panel must have a unique serial number.
Supervision Time: Select the supervision time required for the wireless output. The wireless output
must check in at least once during this time or a missing condition is indicated for that output. DMP
1100 Series transmitters automatically checkin based on the supervision time selected for the wireless