Specifications

Emergency Bell Action Emergency Type zones

Aux 1 Bell Action Auxiliary 1 Type zones

Aux 2 Bell Action Auxiliary 2 Type zones

Miscellaneous Options

Bell Cutoff Time: Enter the maximum time for the bell output to remain on. If the bell output is

manually silenced or the area is disarmed, the cutoff time is reset. Enter 0 (zero) to provide

continuous bell output. Default is 15 minutes unless otherwise noted.

XT30, XT50, XTL, XTLN, XTLN-WiFi - select 1 to 15 minutes (Default is 5)

Note: The XTL/XTLN/XTLN-WiFi does not allow 0 (zero) to be entered in Bell Cutoff Time.

XRSuper6, XR20, XR40 - select 1 to 15 minutes

XR150/XR350/XR550 Series, XR100/XR500 Series, XR2500F - select from 1 to 99 minutes

XR200, XR2400F, or XR200-485(B) - select from 1 to 99 minutes

Automatic Bell Test: When this box is selected, the bell output is turned on for two seconds each

time an area is completely armed from a keypad.

The automatic bell test is delayed until the Closing Wait acknowledgement is received (if selected). If

the Closing Wait acknowledgement is not received within 90 seconds, the bell test will not occur. If

Closing Wait is not selected in the System Options window, the automatic bell test occurs when the

last area arms.

A bell test only occurs when the areas are armed from a keypad. Arming performed from an arming

zone or remotely from Remote Link does not activate a bell test.

Bell Output: Enter the output number when needed to follow the panel bell output operation for all

actions and off conditions on XR150/XR350/XR550 Series, XR100/XR500 Series, XR2500F, XRSuper6,

XR20, or XR40 panels. Enter 0 (zero) to disable the output.

Bell Output (XT30/XT50/XTL/XTLN/XTLN-WiFi): Enter the output/Favorite number to follow the

panel bell terminal 5 operation for all action and off conditions. Enter 0 (zero) to disable the output.

Note: When BELL ACTION is set to T for Temporal Code 3, the output action is Pulse when

connected to:

-an LX-Bus output on an XR150/XR350/XR550 Series, XR100/XR500 Series, or XR2500F panel.

-an output on an XT30, XT50, XRSuper6, XR20, or XR40 panel.

Note: Bell Output should not be programmed for a Model 1135/1135DB Wireless Siren when

programmed in Output Information to Trip with Panel Bell.

Program > Output Options

The Output Options window allows you to assign individual outputs to activate for various events. The

Output Options window also enables you to set the Cutoff Outputs, Output Cutoff Time, and the Heat

and Cool Saver Temperatures.