Specifications

Instant Arm: When selected, the arming keypad displays INSTANT for selection during the exit

countdown delay when arming fewer than all areas of the system. At the time instant arming is

selected, any entry and exit delays programmed for the areas being armed are ignored. The entry

delay for previously armed areas is not affected by instant arming. Default is unselected for an Area

System, and selected for an All/Perimeter, Home/Sleep/Away system, or a Home/Sleep/Away with

Guest system.

C100/FA100 Wireless Arming (XR500): Allow the use of Inovonics remote arming transmitters.

Closing Wait: When this option is selected, the keypad displays "ONE MOMENT..." when an area is

armed. The system waits for an acknowledge signal from the central station before arming the

selected area(s) and performing a bell test, if that option is selected under Program > Output Options.

The panel must receive the acknowledge signal from the central station within 90 seconds. If the panel

does not receive the acknowledge signal from the central station within 90 seconds, the keypad will

display "LOCAL SYSTEM ONLY." Exit delays begin after this 90-second period. The Opening / Closing

and User box in Program > Communications under the Receiver 1 or Receiver 2 tab must be checked to

enable Closing Wait.

Reset Swinger Bypass: When Reset Swinger Bypass is selected, an automatically bypassed zone is

reset if it remains in a normal condition for one complete hour after being bypassed.

The panel sends a report of the automatic reset to the central station if Bypass Reports is checked in

Program > System Reports.

Card Plus PIN (XR500E): When checked, all existing user codes will need a PIN number assigned.

Program the PIN number in Program>User Codes. For door access, arm/disarm, or User Menu access,

the first code must be entered from a proximity patch, credential card, fob, etc., on a reader from a

DMP Keypad (Models 7063, 7163, 7073, 7173, 7872, 7873) or an external reader. The second code is a

PIN number keyed in at the keypad or can be a second credential.

Note: The Card Plus PIN option is only available on Area Systems.

Weather Zip Code (XT30/XT50, XR100/XR500 V212 or higher)

This option allows local U.S.A. weather updates to display on the keypad. Enter the zip code of the

user at this prompt. When no number is entered weather conditions are not displayed. Default is

blank.