Specifications

Access Areas: Enter the area numbers that you wish to grant door access for this device.

- Areas 1 to 32 for XR500 Series, XR550 Series, or XR2500F panels

- Areas 1 to 16 for XR350 Series panels

- Areas 1 to 8 for XR100 Series or XR150 Series panels

Note: Enter the sequence of addresses separated by commas to enable egress areas devices:

i.e.., enter addresses 1 through 4, 6, and 10 through 16 as 1-4, 6, 10-16.

Users must have matching access area numbers assigned to their profile to receive door access at this

device. If you do not enter any area numbers, all users with Door Access authority will receive a door

access without regard to schedules.

If the user code is programmed for anti-passback, the user will be logged into all matching areas. This

user will not be allowed to access these areas again until they have egressed (exited) the area. See

Egress Areas below.

Note: For an XR150/XR350/XR550 Series and XR100/XR500 Series system set to All/

Perimeter, Home/Sleep/Away, or Home/Sleep/Away with Guest system, Access Areas should

be left at factory default settings.

Egress Areas: Use this option to detect anti-passback violations. Enter the desired area numbers.

- Areas 1 to 32 for XR500 Series, XR550 Series, or XR2500F panels

- Areas 1 to 16 for XR350 Series panels

- Areas 1 to 8 for XR100 Series or XR150 Series panels

Users must have matching access area numbers assigned to their profile, to receive a door egress at

this device. If the user is programmed for anti-passback, the user will be logged out of all matching

areas. This will allow the user to again access the area. See Access Areas.

If you do not enter any area numbers, all users with Door Access authority will receive a door access

without regard to schedules. If you are not using the anti-passback feature leave the option blank.

Note: Enter the sequence of addresses separated by commas to enable egress areas devices:

i.e.., enter addresses 1 through 4, 6, and 10 through 16 as 1-4, 6, 10-16.

Note: For an XR150/XR350/XR550 Series and XR100/XR500 Series system set to All/

Perimeter, Home/Sleep/Away, or Home/Sleep/Away with Guest system, Access Areas should

be left at factory default settings.

Display Areas (For an XR150/XR350/XR550 Series and XR100/XR500 panels only): Display

Areas allows the panel burglary activities to be segmented so that only specific area(s) and their

associated operation appear at a particular keypad. Area number(s) selected in this field affect the

way users interact with the system from this particular device. For example: Program Device 1 to

show only the zone activities and armed status of Area 1.

Enter the area number(s) that this keypad is to display. This allows specific area control from specific