Specifications

Device Type (XR100/XR500 Series Version 204 or lower): This allows you to specify the type of

device installed at a particular address on the keypad bus.

None: No device is connected to this address.

Standard: Select Standard if you are connecting to any keypad, zone expander, or a

733/734/734N/734N-WiFi Wiegand Interface Module.

Fire: A Model 630F Remote Fire Command Center is connected to this address.

Device Type (XR100, XR500 Series Version 205 or 206):

This allows you to specify the type of device installed at a

particular address on the keypad bus.

None: No device is connected to this address.

Door: The device is an access control device and is either a

keypad or a Wiegand Interface Module.

Fire: The device is a 630F Remote Annunciator.

Keypad: The device is either a keypad or a zone expander

device.

Device Type (XR150/XR350/XR550 Series and XR100/XR500 Series Version 207 or higher):

This allows you to specify the type of device installed at a particular address on the keypad bus.

Door: The device is an access control device and is either a keypad or a Wiegand Interface

Module.

Fire: The device is a 630F Remote Annunciator.

Keypad: The device is a keypad.

Zone Expander: The device is a zone expansion module.

Device Communication Type: For a Device Type of Door, select Keypad Bus to

communicate with a device on the keypad bus or select Network to communicate

with a device using a network connection. Default is Keypad Bus.

For a Device Type of Keypad, select Keypad Bus to communicate with a device on

the keypad bus or select Wireless to communicate with a device that uses a

wireless connection. Default is Keypad Bus.

Serial Number: Enter the eight-digit serial number found on the wireless keypad.

Supervision Time: Select the supervision time required for the wireless device. The device must

check-in at least once during this time or a missing condition is indicated. Zero (0) indicates an

unsupervised wireless keypad. Default is 240 minutes.

Note: When the panel is reset or a receiver is installed or powered down and powered up, or

Remote Link disconnects, the supervision timer restarts for all wireless zones.