Specifications

must be the same port that is programmed in Panel IP Port within the 734N

Communication programming menu.

734N Passphrase (XR150/XR350/XR550 Series and XR100/XR500 Version 209 or above):

Enter an 8 to 16-character Passphrase to encrypt communication with the 734N

module. The 734N Passphrase must match the 734N Passphrase entered in

Communication programming of the 734N. The Passphrase is blank by default.

Note: A passphrase is required for operation.

Program > Messaging Setup

The Messaging Setup window allows you to enter the information needed to send messages from the

panel to a given destination via email and In Touch™ SMS Text using Network or Cellular

communication. SMS text can also be used to send cellular text commands to the panel, such as

arming and disarming. All of the name and password options below allow up to 32 lowercase characters

to be entered. The Destination addresses allow up to 48 characters to be entered.

Setup

Enable Messaging: Allows the panel to send messages to three programmed destinations.

System Name: Enter a name for the panel. The panel name will be used as the sender of the

message. If this field is left blank, the panel account number will be sent.

Destination

Destination 1 (XT30, XT50, XTL, XR100, XR500, and XR150/XR350/XR550 Series): Enter the

first destination email address or cell phone number where messages will be sent. The message can be

sent to any device (computer, cell phone, PDA) as long as a valid email address or 10-digit cell phone

number is entered.