Specifications

When FIRE is selected, Zone Trouble, Low Battery, Missing, Fault, Restorals from trouble, System

Troubles (A/C, Phone Line, Panel Battery) and System Restoral reports are sent for Fire, Fire

Verify, and Supervisory Zones.

Note: Serviceman reports are sent regardless of the selection made for Supervisory/Trouble

reports.

Opening/Closing and User Reports: This prompt displays when the Path Type is Primary. All backup

paths within the group follow the same programming for Opening/Closing and User Reports. Default is

Yes.

When YES is selected, the following reports by user are sent to this receiver. Default is Yes.

Opening

Closing

Bypass

Reset

Code changes (including adding, deleting, changing)

Schedule changes (temporary, permanent, shift)

Holiday date changes

Door Access Report: This prompt displays when the Path Type is Primary. All backup paths within

the group follow the same programming for Door Access Reports. Default is Yes.

When YES is selected, Door Access Granted and Denied reports are sent to this receiver. The Door

Access Granted report is only sent if the keypad number has also been selected in Access Keypads

under the SYSTEM REPORTS programming.

When DENY is selected, Door Access Denied reports are sent to this receiver when a door access is

denied to a user.

Panic Test (XR550 with Network or Encryption and XR500N or XR500E Version 210 or later

only): Allows the panel to send panic zone test verification and failure results to the central station.

Leaving this option blank instructs the panel to not send panic zone test results. The system test

start, stop, panic zone verification, and panic zone failure messages sent to the central station and

the trips count operation is the same as used under Walk test.

Note: When a Panic Test is initiated from the keypad and the Model 1116 wireless relay output

connected to an LED annunciator or a Model 1118 remote indicator is installed, the LED

annunciator flashes quickly for five minutes.

Program > Netw ork Options

The Network Options window allows you to set the IP address for the XR150/XR350/XR550 Series with

Network, XR100N, XR500N, XR500E, XT30, XT50, XTLN, or XTLN-WiFi panel.