Specifications

number in place of PPPPP. The default port number is 2001.

Check the box beside Host Backup Enable. Enter the retry and check-in times.

Explanation:

Messages will be sent through the 462N card to the iCOM/iCOM-E, then to the Main SCS-1 or SCS-1R

Receiver. If the messages cannot be sent using that route, the panel will use the Host Setup String to

direct the messages to the backup receiver. If the panel cannot send the messages to the backup

receiver, the panel will then use the communication type entered under 2nd Line of Method Tab.

Example 3: Other Network Devices

It is also possible to use other network devices for the backup. You may use a cellular radio to route

messages to the receiver. If you are using a network device other than an iCOM/iCOM-E, you will

need to obtain the Host (Modem) Setup String for the network device. Generally the Setup String can

be found in the literature provided with the device.

You may use the examples above as a guide when programming you network device. The major

difference between programming an iCOM/iCOM-E for backup and another network device is the Host

Setup String is needed with non-DMP network devices.

Program > Comm unicatio ns> Advanced Communications

XT30/XT50 Series Panels (Version 102 or earlier)

1st IP Address: Enter the first (primary) IP address where the panel sends network or cell messages.

The IP address must be unique and cannot be duplicated on the network. Enter all 12 digits and leave

out the periods. For example, enter IP address 192.168.0.250 as 192168000250. The periods display

automatically.