Specifications

XT Series (Version 103 or higher), XTL, XTLN, and XTLN-WiFi panels

Alarms: Sends Abort, Alarm, Alarm Restoral, Ambush, Exit Error, and System Recently Armed reports

to Receiver 1.

Supervisory / Troubles: Sends Supervisory, Trouble, Trouble Restoral, Force Armed, Zone Fault

reports, and Service man messages to Receiver 1.

Opening / Closing and User: Sends Opening, Closing, Door Access, Late to Close, Unauthorized

Entry, Schedule and Code changes, Zone Reset, and Zone Bypass reports to Receiver 1.

Test Report: Enables the panel to send the automatic recall test report to Receiver 1. The panel

sends the automatic recall test reports as determined by the programming in the Test Timer tab.

1st Phone No: Enter the primary phone number for the panel to use for communication with Receiver

2nd Phone No: Enter the secondary phone number for the panel to use for communication with

Receiver 1. The receiver dials this number if there is a problem with the first phone number.

Note: All phone numbers can be up to 32 characters. You may program a 3-second delay in the dialing

sequence by entering the letter P. You may also program a dial tone detect by entering the letter D.

These characters are counted as part of the 32 allowable characters.

1st IP Address: Enter the first (primary) IP address where the panel sends network or cell messages.

The IP address must be unique and cannot be duplicated on the network. Enter all 12 digits and leave

out the periods. For example, enter IP address 192.168.0.250 as 192168000250. The periods display

automatically.

Note: For Network: The first and second IP addresses are alternately used for 8-second

intervals until successful communication or 1 minute elapses.

1st IP Port: Enter the first IP port number to be used in conjunction with the First IP Address. The IP

port identifies the port used to communicate messages to and from the panel. The default IP Port

setting is 2001

2nd IP Address: Enter the second IP address where the panel sends network messages. The IP

Address must be unique and cannot be duplicated on the network.